| 1.The torsion bar also turns the output of the steering gear, connecting to either the pinion gear or the _____ gear depending on which type of steering the car has. |
|
|
| 2. His grandfather is very healthy. He _________ drinks _________ smokes. |
|
|
| 3.The tire loads include three load groups: side load, radial load and ______. |
|
|
| 4.The ______ tire has the greatest steering sensitivity. |
|
|
| 5.The classroom is not big enough for 50 students. Yes, I agree. It’s ______. |
|
|
| 6.The book was rather expensive, but I bought it ______. |
|
|
| 7.In a head-on collision with a fixed obstacle at _______km/h, a three-point seat belt can only offer limited protection. |
|
|
| 8.The ______ warning light on the dash will light if either side fails, alerting you to the problem. |
|
|
| 9.The distance between the centerline of the rim and the mounting face of the disc is called ______. |
|
|
| 10._________ of these two books do you prefer? |
|
|
| 11.The buses, ______ were full of people, couldn’t go very fast. |
|
|
| 12.As the vanes spin, they pull hydraulic fluid from the return line at ______ pressure and force it into the outlet at high pressure. |
|
|
| 13.I’m bad at spelling, but Jane is ________than me. |
|
|
| 14.Chris usually goes to the gym ________ the weekend. |
|
|
| 15.As she ______ the newspaper, Granny ______ asleep. |
|
|
| 16.If the level drops noticeably over a short period of time or goes ______ to about two thirds full, have your brakes checked as soon as possible. |
|
|
| 17.By retracting and tightening the belt strap, the ______ compensates for “belt slack” and “film-reel effect” in a collision. |
|
|
| 18.It would contain sensors that tell the car what the driver is doing with the wheel, and have some motors in it to provide the driver with _______ on what the car is doing. |
|
|
| 19.I have no idea who stole his wallet. It ________ anyone. |
|
|
| 20.You’d better have your hair ______ before going to your friend’s wedding. |
|
|
| 21.The manufactures are using passive safety design technology to develop frames of _______ sizes,variations, and composition. |
|
|
| 22.Today is too busy. Let’s discuss it _____ next week. |
|
|
| 23.Mary said she ______ all over the world. |
|
|
| 24.On a disk brake, the fluid from the master cylinder is forced into a caliper where it presses against a _______. |
|
|
| 25.Radial tires were first used on ______ because they produce good steering sensitivity. |
|
|
| 26.I’m sorry to have kept you waiting. Oh, not at all, I ______ here only a few minutes. |
|
|
| 27.______ of the coolest ideas on the drawing board is the "steer-by-wire" or "drive-by-wire" system. |
|
|
| 28.The torsion bar is a thin rod of metal that twists when _______ is applied to it. |
|
|
| 29.When the tire is on a dry asphalt surface, the maximum frictional force of the tire (without sliding) is usually between ______ of the radial load. |
|
|
| 30.The condition of ______ means that the smooth tire rides up on the surface water. |
|